...
-Under MCP Actions → start from the bottom up, waiting until each action goes ‘idle’ before moving onto the next.
If done properly your MMS should be in Control4 mode and your outputs assigned to reflect your Control4 amp/processor.
IE, use case, consider 2 - m801e’s, a total of 16 zones, zones 7 & 8 are pre-outs.
...
Make sure to have both amps on the same System ID by default they should both be on 'System ID -1'
You can find this by going to the ampIP/Config → Amplifier tab
C4 will take over the Autonomic Amps, there is no need to modify ampIP/config settings.
~~~~~~
FAQs
Spinning Wheel - c4 configuration includes a MMS + Amps.
...