Please check out this video for some best practice tips!
Main Takeaways
You should have the following drivers installed for the MMS, always make sure to have the most up to date Autonomic Drivers.
-MCP Driver
-Instance Drivers for outputs, ie Player_A
-Instance Driver for Streaming Service, ie Spotify.
Once everything is configured for the MMS and your Control4 system please go to the MCP driver, navigate to the Action buttons.
-MCP Actions → start from the bottom up, waiting until each action goes ‘idle’ before moving onto the next.
If done properly your MMS should be in Control4 mode and your outputs assigned to reflect your Control4 amp/processor.
IE, use case, consider 2 - m801e’s, a total of 16 zones, zones 7 & 8 are pre-outs.
In Control4’s view one big amp, please configure your endpoints as such
1-16
if not using zone 7 and 8 on the first amp please continue to program your endpoints for zone 9, 10 etc..
Considering amp drivers in Control4, in most applications you’ll only 1 driver, if you have 2 or more amps the 1 driver will be able to see the other amps. You can confirm this by viewing the other MACs listed under the driver page.